setsnmp

Configures system parameters for SNMP. You can configure the management station address to receive system traps using this command.

Syntax


 setsnmp -n system_name -c system_contact -L system_location 

-r read_community_string -w write_community_string 

-1 manager_address1 -2 manager_address2 -3 manager_address3 

-4 manager_address4

Options

-n	System name (up to 31 characters).
-c	System contact (up to 31 characters).
-L	System location (up to 63 characters).
-r	Read community string.
-w	Write community string.
-1	IP address of manager station1.
-2	IP address of manager station2.
-3	IP address of manager station3.
-4	IP address of manager station4.

Note

Only the parameters relevant to the task you are performing need to be specified.

Example


 setsnmp -n system1 -1 205.15.3.20

This command will configure the system name as system1 and set up the management station address to be 205.15.3.20.

Also Supported on